Intermittent Amplifier: 210

1. Connect jumper wires as shown for first test. See Fig 2. Test lamp should come on for 1 second and go off for 6 seconds. Connect wires for second test.
2. Test lamp should come on about 1 second after jumper wire is connected to pin 2. Leave jumper connected for about 5 seconds, then remove it. Test lamp should come on for about 3 seconds.
3. If amplifier fails either test, replace it. Check system operation in all modes.

Fig 1: Test Connections 200SX & 280ZX Intermittent Amplifier

Courtesy of NISSAN NORTH AMERICA, INC.

280ZX variable intermittent amplifier is tested in the same manner. 

Fig 2: Test Connections for 210 Intermittent Amplifier

Courtesy of NISSAN NORTH AMERICA, INC.

Variable intermittent system not availably on 210 models.