LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 1982 >> 280ZX Base, 2.8L Eng VIN C, Automatic Trans >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Electronic Concentrated Engine Control >> Testing >> Component Testing >> Ignition Signal Circuit

Ignition Signal Circuit

  1. Disconnect starter motor "S" terminal and connect battery ground cable. Turn ignition switch to "START".
  2. Measure voltage between control unit connector pin 9 and ground. If battery voltage is not present, check harness and ignition coil.
scientia non olet · About LEMON Manuals