Probing from Harness Side

Standard type (not waterproof type) connector should be probed from harness side with "T" pin.

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

• If the connector has a rear cover such as a ECM connector, remove the rear cover before probing the terminal.
• Do not probe waterproof connector from harness side. Damage to the seal between wire and connector may result.

FEMALE TERMINAL

• There is a small notch above each female terminal. Probe each terminal with the "T" pin through the notch.

  Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

  Do not insert any object other than the same type male terminal into female terminal.

• Some connectors do not have a notch above each terminal. To probe each terminal, remove the connector retainer to make contact space for probing.

  Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

  MALE TERMINAL

• Carefully probe the contact surface of each terminal using a "T" pin.

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.