LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2024 >> Outlander SE, AWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission >> Basic Inspection >> Stall Test >> Work Procedure >> Inspection

Work Procedure: Inspection

  1. Check the engine oil level. Replenish if necessary. Refer to INSPECTION .
  2. Check for leak of the CVT fluid. Refer to INSPECTION .
  3. Drive for about 10 minutes to warm up the vehicle so that the CVT fluid temperature is 50 to 80°C (122 to 176°F).
  4. Be sure to apply the parking brake and block the tires.
  5. Start the engine, depress the brake pedal and shift to the D position.
  6. While depressing the brake pedal, depress the accelerator pedal gradually.
  7. Read the stall speed quickly. Then, release your foot from the accelerator pedal quickly.
    CAUTION: Never depress the accelerator pedal for 5 seconds or more during the test.
    Stall speed : Refer to STALL SPEED 
  8. Shift the N position.
  9. Cool the CVT fluid.
    CAUTION: Run the engine with the idle speed for at least 1 minute.
  10. Put the selector lever to the R position and perform Step  6 to Step  9 again.
scientia non olet · About LEMON Manuals