Diagnosis Procedure
WARNING: This page is about a different car, the 2023 Mitsubishi Outlander PHEV. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK OUTPUT CIRCUIT
- Electric motor switch ON.
- Turn ON any switch in the system that is malfunctioning.
- Check duty ratios between BCM harness connector and ground by using an oscilloscope.
System + - Output waveform BCM Connector Terminal Output 1 M19 48 Ground Refer to REFERENCE VALUE . Output 2 49 Output 3 53 Output 4 52 Output 5 50 Output 6 51 Is the inspection result normal?
YES >>
Check intermittent incident. Refer to Intermittent Incident INTERMITTENT INCIDENT .
NO-1 >>
Fixed to 0 V:
GO TO 2.
NO-2 >>
Fixed to 9 - 16 V: Replace BCM. Refer to REMOVAL AND INSTALLATION .
- CHECK OUTPUT CIRCUIT FOR OPEN
- Electric motor switch OFF.
- Disconnect BCM connector.
- Check continuity between BCM harness connector and combination switch harness connector.
System BCM Combination switch Continuity Connector Terminal Connector Terminal Output 1 M19 48 M28 7 Existed Output 2 49 15 Output 3 53 10 Output 4 52 5 Output 5 50 2 Output 6 51 12 Is the inspection result normal?
YES >>
GO TO 3.
NO >>
Repair harnesses or connector.
- CHECK OUTPUT CIRCUIT FOR SHORT
Check for continuity between BCM harness connector and ground.
System BCM - Continuity Connector Terminal Output 1 M19 48 Ground Not existed Output 2 49 Output 3 53 Output 4 52 Output 5 50 Output 6 51 Is the inspection result normal?
YES >>
Replace combination switch. Refer to REMOVAL AND INSTALLATION .
NO >>
Repair harnesses or connector.