Work After TCM And Transaxle Assembly Replacement
- TCM programmingNOTE: Since vehicle specifications are not yet written in a new TCM, it is necessary to write them with M.U.T.-III SE.
- Checking that the serial number recorded on the attached CD matches the serial number on transaxle assembly.
- MAC key writing
- Calibration data (IP characteristics value) writingNOTE: TCM performs accurate control by retrieving data (inherent characteristic value) of each solenoid. For this reason, after replacing transaxle assembly, it is necessary to write new data in TCM.
- New calibration data checking
- Select learning (Drive/Reverse learning)
- Clutch point learning
- Select learning (Drive/Reverse learning)
- G sensor calibration
- Shift actuator learning