LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2024 >> Outlander ES, FWD >> Repair and Diagnosis >> Electrical >> Body Electrical >> Power Control System (IPDM E/R) >> System Description >> System >> Relay Control System >> Fail-safe >> Fail-Safe Control By DTC

Fail-Safe Control By DTC

IPDM E/R performs fail-safe control when any DTC are detected.

DTC No. M.U.T.-III SE display Fail-safe
B121A-11 FR FOG LIGHT LH PWR SPLY CIRC [CIRCUIT SHORT TO GROUND] Shuts off the power supply to the front fog light LH power supply circuit until the front fog light ON conditions are no longer satisfied.
B1256-11 FR FOG LIGHT RH PWR SPLY CIRC [CIRCUIT SHORT TO GROUND] Shuts off the power supply to the front fog light RH power supply circuit until the front fog light ON conditions are no longer satisfied.
B12A4-81 Battery current sensor [INVALID SERIAL DATA RECEIVED] Fix the power generation command value to 14.3 V.
B12A4-92 Battery current sensor [PFM/INCORRECT OPERATN]
B20A2-87 Headlight (RH) LIN communication [MISSING MESSAGE]
  • Transmits the headlight warning signal (CAN communication) to the combination meter. (When the ignition switch turns ON, the headlight warning is displayed on the information display of the combination meter.)
  • Transmits the request signal (via LIN communication) to the both side LED headlight control module, and turns ON the headlight (LO) and parking light.
B20A4-87 Headlight (LH) LIN communication [MISSING MESSAGE]
B20C7-11 A/C clutch [CIRCUIT SHORT TO GROUND] Inhibit A/C compressor (magnetic clutch) operation.
B20C7-15 A/C clutch [CIRC SHORT TO BATT OR OPEN]
B20C8-14 Compressor (ECV) [CIRC SHORT TO GRND OR OPEN] Inhibit A/C compressor (electrical control valve) operation.
B20D4-11 TAIL LIGHT LH PWR SPLY CIRC [CIRCUIT SHORT TO GROUND] Shuts off the power supply to the following power supply circuits until the license plate light, side marker light and tail light ON conditions are no longer satisfied.
  • Tail light
  • License plate light
  • Side marker light
B20E2-96 LED HEADLIGHT RH [CMPNENT INTERNAL MLFNCTN]
  • Transmits the headlight warning signal (CAN communication) to the combination meter. (When the ignition switch turns ON, the headlight warning is displayed on the information display of the combination meter.)
  • Transmits the request signal (via LIN communication) to the both side LED headlight control module, and turns ON the headlight (LO) and parking light.
B20E3-96 LED HEADLIGHT LH [CMPNENT INTERNAL MLFNCTN]
U0073-00 Control module comm Bus A Off [NO SUBTYPE INFO] Refer to CAN COMMUNICATION CONTROL of following.
U2140-87 CAN comm err (ECM) [MISSING MESSAGE]
U214F-87 CAN comm err (BCM) [MISSING MESSAGE]
scientia non olet · About LEMON Manuals