Detailed Flow

INTERVIEW FOR MALFUNCTION
It is also important to clarify the customer concerns before starting the inspection. Interview the customer about the concerns carefully and understand the symptoms fully.

NOTE: The customers are not professionals. Never assume that "maybe the customer means" or "maybe the customer mentioned this symptom".

>>

GO TO 2.
SELF-DIAGNOSIS WITH M.U.T-III SE
With M.U.T.-III SE

Perform self-diagnosis of "Wireless charger" using M.U.T.-III SE. Refer to M.U.T-III SE Function M.U.T.-III SE FUNCTION .

NOTE: Skip to step 4 of the diagnosis procedure if "Wireless charger" is not displayed.

Is any DTC detected?

YES >>

GO TO 3.

NO >>

GO TO 4.
TROUBLE DIAGNOSIS FOR DTC
1. Check the DTC indicated in the "Self Diagnostic Result".
2. When DTC is detected, follow the instructions below
  - Record DTC
  - Freeze Frame Data (FFD)
3. Perform the relevant diagnosis referring to the DTC Index. Refer to DTC INDEX .
>>

GO TO 6.
RESET THE SYSTEM
Disconnect and connect the negative (-) terminal of the battery. Refer to the " Required Procedure After Battery Disconnection " .

>>

GO TO 8.
SYMPTOM DIAGNOSIS
Perform the applicable diagnosis according to the diagnosis chart by symptom. Refer to Symptom Table DIAGNOSIS CHART BY SYMPTOM .

>>

GO TO 6.
MALFUNCTIONING PART REPAIR
Repair or replace the identified malfunctioning parts.

>>

GO TO 7.
REPAIR CHECK (SELF-DIAGNOSIS WITH M.U.T.-III SE)
With M.U.T.-III SE
1. Erases self-diagnosis results.
2. Perform self-diagnosis of "Wireless charger" again after repairing or replacing the specific items.
3. Check if any DTC is detected in self-diagnosis results of "Wireless charger".
Is any DTC detected?

YES >>

GO TO 3.

NO >>

GO TO 8.
REPAIR CHECK (OPERATION TEST)
Perform operation test. Check that the malfunction symptom is solved or no other symptoms occur.

Is there a malfunction symptom?

YES >>

GO TO 5.

NO >>

INSPECTION END