Required Tools

WARNING: This page is about a different car, the 2024 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.

The following tools are necessary to perform distance sensor alignment:

Radar Sensor Aiming Kit 1-20-2851-1 Kit includes the following:

Target Board (Fixture)
Laser assembly
Rear Stand

Use kit 1-20-2851-1 with a self-centering wheel adapter (e.g. 1-20-2722-1-IF, Hunter 20-3339-1 or equivalent).

NOTE: *Tools 1-20-2721-1-IF, 1-20-2722-1-IF and J-50808 have been superseded and are no longer available, but may still be used for distance sensor alignment.

Target board.

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
1. (1): Position 1, with top tilted 2° toward vehicle (Not used).
2. (2): Position 2, vertical.
3. (3): Position 3, with top tilted 2° away from vehicle (Not used).
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Hunter self-centering wheel adapter (1) [shown with laser assembly (2) installed] (Hunter alignment rack head may be substituted).
NOTE: Directional arrows (A) and (B) are shown to illustrate the direction of the laser assembly beams.
Laser assembly (with bi-directional laser beam) as shown in the illustration.

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
1. Tightening knob (1)
2. Power ON/OFF button (2)
3. Front laser beam opening (3)
4. Rear laser beam opening (4)
5. Attaching shaft (5)
Rear stand as shown in the illustration.

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
1. Rear stand (1)
2. Laser signal reception plate (2)
Distance chain (not shown)