LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2023 >> Outlander ES, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (DTC/Circuit Diagnosis) (5 Of 5) >> DTC/Circuit Diagnosis >> A/F Sensor 1 >> Component Function Check

Component Function Check

  1. PERFORM COMPONENT FUNCTION CHECK 

    With GST

    1. Start engine and warm it up to normal operating temperature.
    2. Drive the vehicle at a speed of 80 km/h (50 MPH) for a few minutes in the suitable gear position.
    3. Shift the selector lever to the D position, then release the accelerator pedal fully until the vehicle speed decreases to 50 km/h (31 MPH).
      CAUTION: Always drive vehicle at a safe speed.
      NOTE: Never apply brake during releasing the accelerator pedal.
    4. Repeat steps  2 to  3 for five times.
    5. Stop the vehicle and turn ignition switch OFF.
    6. Wait at least 10 seconds and restart engine.
    7. Repeat steps  2 to  3 for five times.
    8. Stop the vehicle.
    9. Check 1st trip DTC.

    Is 1st trip DTC detected? 

    YES >>

    Proceed to Refer to DTC DIAGNOSIS PROCEDURE .

    NO >>

    INSPECTION END

scientia non olet · About LEMON Manuals