LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2022 >> Outlander PHEV LE >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Transaxle >> Rear Transaxle >> On-Vehicle Service >> Transaxle Fluid Check

Transaxle Fluid Check

  1. Remove the rear differential support weight B.
    G14352699Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Remove the filler plug and gasket.
    G14352700Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  3. Check that the fluid level is just below the lower edge of the filler plug hole.
  4. Check that the fluid is not excessively foul and has moderate viscosity.
  5. If the level is below the filler plug hole, add the specified fluid up to the end of the filler plug hole.

    Brand name: 

    MITSUBISHI MOTORS GENUINE ATF SP III 

    G14352701Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  6. Install the filler plug and new gasket, and tighten to the specified torque.

    Tightening torque: 32 ± 2 N.m (24 ± 1 ft-lb) 

  7. Install the rear differential support weight B.
Fig 1: Rear Differential Support Weight B Bolts With Toque Specification
G14352702Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals