Cruise Control Switch Check
- Remove the cruise control switch (Refer to STOPLIGHT SWITCH CHECK .)
- Measure the resistance between terminal number 3 and terminal number 4 when each of the "CRUISE ON/OFF", "CANCEL", "SET-" and "RES+" switches is pressed. If the values measured at the time each switch is pressed correspond to those in the table below, the resistance values are correct.
Terminal connector of tester Switch position Specified condition 3 - 4 All switches are released. Open circuit "CRUISE ON/OFF" switch is pressed Continuity (less than 2 ohms) "CANCEL" switch is pressed 203 - 207 Ω "SET-" switch is pressed 611 - 623 Ω "RES+" switch is pressed 1839 - 1875 Ω - Check that illumination of the cruise control switch turns on when the battery positive terminal is connected to cruise control switch connector terminal No. 5, and the battery negative terminal is connected to cruise control switch connector terminal No. 6.