Oscilloscope Inspection Procedures: Notes
WARNING: This page is about a different variant/trim than selected.
 Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
|
| TERMINAL NUMBER |
TERMINAL CODE |
CHECK ITEM |
CHECK CONDITION |
WAVE PATTERN |
| 1 |
PLLS |
Line pressure solenoid valve |
- Engine: Idling
- Selector lever position: "P"
|
Waveform A |
| 2 |
PRLS |
Primary pressure solenoid valve |
| 3 |
LBLS |
Low brake solenoid valve |
- Selector lever position: "D"
- Drive at a constant speed of approximately 20 km/h (12.4 mph)
|
| 41 |
HRLS |
High clutch and reverse brake solenoid valve |
| 52 |
LULS |
Lockup solenoid valve |
- Driving conditions
- Lockup engaged
|
| 32 |
OUTS |
Output speed sensor |
- Selector lever position: "D"
- Drive at a constant speed of approximately 20 km/h (12.4 mph)
|
Waveform B |
| 33 |
PRMS |
Primary pulley speed sensor |
- Selector lever position: "L"
- Drive at a constant speed of approximately 20 km/h (12.4 mph) (auxiliary gearbox: at 1st gear)
|
- Selector lever position: "L"
- Drive at a constant speed of approximately 20 km/h (12.4 mph) (auxiliary gearbox: at 2nd gear)
|
| 34 |
SECS |
Secondary pulley speed sensor |
- Selector lever position: "D"
- Drive at a constant speed of approximately 20 km/h (12.4 mph) (auxiliary gearbox: at 1st gear)
|
- Selector lever position: "D"
- Drive at a constant speed of approximately 20 km/h (12.4 mph) (auxiliary gearbox: at 2nd gear)
|