| Communication with scan tool (M.U.T.-III) is not possible |
Communication with engine control module (ECM) is not possible |
- |
INSPECTION PROCEDURE 1: COMMUNICATION WITH ECM IS NOT POSSIBLE
. |
| When the brake pedal is depressed, cruise control is not cancelled |
1 |
INSPECTION PROCEDURE 1: WHEN THE BRAKE PEDAL IS DEPRESSED, CRUISE CONTROL IS NOT CANCELLED |
| When the clutch pedal is depressed, cruise control is not cancelled <M/T> |
2 |
|
| When the selector lever is set to "N" position, cruise control is not cancelled <CVT> |
3 |
|
| When the "CANCEL" switch is pressed, cruise control is not cancelled |
4 |
INSPECTION PROCEDURE 4: WHEN THE "CANCEL" SWITCH IS PRESSED, CRUISE CONTROL IS NOT CANCELLED |
| Cruise control cannot be set (No response "SET-" switch and "RES+" switch is pressed) |
5 |
INSPECTION PROCEDURE 5: CRUISE CONTROL CANNOT BE SET (NO RESPONSE "SET-" SWITCH AND "RES+" SWITCH IS PRESSED) |
| Hunting (repeated acceleration and deceleration) occurs at the set vehicle speed <M/T> |
6 |
|
| Hunting (repeated acceleration and deceleration) occurs at the set vehicle speed <CVT> |
7 |
|
| When the cruise control ON/OFF switch is turned ON, the cruise control indicator light does not illuminate (However, the cruise control system is normal) |
8 |
INSPECTION PROCEDURE 8: WHEN THE CRUISE CONTROL ON/OFF SWITCH IS TURNED ON, THE CRUISE CONTROL INDICATOR LIGHT DOES NOT ILLUMINATE (HOWEVER, THE CRUISE CONTROL SYSTEM IS NORMAL) OPERATION |
| When the cruise control switch is operated, the system is not turned on |
9 |
INSPECTION PROCEDURE 9: WHEN THE CRUISE CONTROL SWITCH IS OPERATED, THE SYSTEM IS NOT TURNED ON |