Trouble Symptom Chart
WARNING: This page is about a different car, the 2017 Mitsubishi Mirage G4. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- During troubleshooting, a DTC associated with another system may be stored when the ignition switch is turned on with connector(s) disconnected. On completion, confirm all systems for DTCs. If DTCs are stored, erase them all.
- When the combination meter is required to be replaced as a result of the troubleshooting, the current driving distance and number of elapsed days to be used for service reminder function must be entered into the meter after the replacement. Therefore, read "Integrated mileage for reminder," "Integrated days for reminder," "Mileage until Extra reminder," "Months until Extra reminder," and "Current Schedule" from the meter before the replacement using the special function of scan tool (M.U.T.-III), and note them. For the operation method of scan tool (M.U.T.-III), refer to
SERVICE REMINDER FUNCTION SET . If "Integrated mileage for reminder" or "Integrated days for reminder" cannot be read by the scan tool (M.U.T.-III), follow the method described below.
- For the driving distance for check warning, use the driving distance displayed on the multi information display.
- For the elapsed days for check warning, calculate the number of elapsed days from the delivery date to the customer (service remainder function start date) and current date.
| Trouble symptom | Inspection Procedure No. | Reference page |
|---|---|---|
| Power supply circuit check | 1 | SYMPTOM PROCEDURES |
| The odometer and the trip meter are not displayed. | 2 | |
| No needle meters work. | 3 | |
| If the ignition switch is turned to the "ON" position, the indicator and warning lights do not illuminate normally. | 4 | |
| The speedometer does not work (the other meters work). | 5 | INSPECTION PROCEDURE 5: THE SPEEDOMETER DOES NOT WORK (THE OTHER METERS WORK) |
| The tachometer does not work (the other meters work). | 6 | INSPECTION PROCEDURE 6: THE TACHOMETER DOES NOT WORK (THE OTHER METERS WORK) |
| Tone alarm does not sound normally. | 7 | INSPECTION PROCEDURE 7: TONE ALARM DOES NOT SOUND NORMALLY |
| Fuel gauge does not work (the other meters work). | 8 | INSPECTION PROCEDURE 8: FUEL GAUGE DOES NOT WORK (THE OTHER METERS WORK) |
| The combination meter light does not illuminate normally or the multi-information display is not displayed normally. | 9 | INSPECTION PROCEDURE 9: THE COMBINATION METER LIGHT DOES NOT ILLUMINATE NORMALLY OR THE MULTI-INFORMATION DISPLAY IS NOT DISPLAYED NORMALLY |
| The multi-information display screen cannot be changed with the operation of the multi-information display switch. | 10 | INSPECTION PROCEDURE 10: THE MULTI-INFORMATION DISPLAY SCREEN CANNOT BE CHANGED WITH THE OPERATION OF THE MULTI-INFORMATION DISPLAY SWITCH |
| Parking brake reminder tone alarm does not sound. | 11 | INSPECTION PROCEDURE 11: PARKING BRAKE REMINDER TONE ALARM DOES NOT SOUND; INSPECTION PROCEDURE 12: BRAKE WARNING LIGHT DOES NOT ILLUMINATE |
| Brake warning light does not illuminate. | 12 | |
| Ambient temperature sensor does not work. | 13 | INSPECTION PROCEDURE 13: AMBIENT TEMPERATURE SENSOR DOES NOT WORK |
| Seat belt reminder function does not work normally. | 14 | INSPECTION PROCEDURE 14: SEAT BELT REMINDER FUNCTION DOES NOT WORK NORMALLY |
| Washer fluid level warning light does not illuminate. <Vehicles for Canada> | 15 | INSPECTION PROCEDURE 15: WASHER FLUID LEVEL WARNING LIGHT DOES NOT ILLUMINATE. <VEHICLES FOR CANADA> |