Diagnostic Trouble Code Chart

WARNING: This page is about a different car, the 2019 Mitsubishi Mirage G4. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

During troubleshooting, a DTC associated with other system may be stored when the ignition switch is turned on with connector(s) disconnected. On completion, check all systems for DTCs. If DTCs are stored, erase them all.
When the combination meter is required to be replaced as a result of the troubleshooting, the current driving distance and number of elapsed days to be used for service reminder function must be entered into the meter after the replacement. Therefore, read "Integrated mileage for reminder," "Integrated days for reminder," "Mileage until Extra reminder," "Months until Extra reminder," and "Current Schedule" from the meter before the replacement using the special function of scan tool (M.U.T.-III), and note them. For the operation method of scan tool (M.U.T.-III), refer to SERVICE REMINDER FUNCTION SET . If "Integrated mileage for reminder" or "Integrated days for reminder" cannot be read by the scan tool (M.U.T.-III), follow the method described below.
1. For the driving distance for check warning, use the driving distance displayed on the multi information display.
2. For the elapsed days for check warning, calculate the number of elapsed days from the delivery date to the customer (service remainder function start date) and current date.

DTC No.	Diagnostic item	Reference
B1200	Odometer failure
B1201	Fuel information problem
B1209	Test mode
B2463	Rheostat switch sticking
U0100	Engine CAN timeout
U0101	T/M CAN timeout
U0121	ABS/ASC CAN timeout
U0131	EPS CAN timeout
U0141	ETACS CAN timeout
U0151	SRS-ABG CAN timeout
U0154	OCM CAN timeout
U0168	WCM/F.A.S.T. CAN timeout
U1000	OSS/F.A.S.T.JDSS CAN timeout
U1110	A/C CAN timeout/Not equipped
U1190	No receive fault detect signal
U1195	Coding not completed