Installation - PDC Assembly
WARNING: This page is about a different car, the 2020 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Position the upper PDC tray to the PDC base (3) in the engine compartment.
- Connect the three bulkhead connectors (2) located in the base of the PDC to the upper PDC tray bottom.
- Securely tighten the fasteners (2) through the upper PDC tray (1).
- Connect all power feeds to their proper PDC posts (3).
- Install the PDC cover onto the PDC assembly.
- Install the positive (B+) Power from the battery before touching the metal fasteners on the Z case fuses.
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.