LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2019 >> Eclipse Cross SP >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> Fuel Supply >> On-Vehicle Service >> Fuel Tank Differential Pressure Sensor Check

Fuel Tank Differential Pressure Sensor Check

  1. Remove the rear seat Assembly (Refer to REAR SEAT ASSEMBLY ), and turn up the floor carpet.
  2. Remove the floor inspection lid (LH).
    G10222593Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  3. Disconnect the fuel tank differential pressure sensor connector.
    G05430938Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  4. Connect special tool test harness set (MB991658) between the terminals of the disconnected connector.
  5. Turn the ignition switch to "ON" position and measure the voltage between terminal 1 and ground.

    Standard value: 2.0 - 3.0 V 

  6. If not within the standard value, replace the fuel tank differential pressure sensor.
  7. Connect the fuel tank differential pressure sensor connector.
  8. Install the inspection lid.
  9. Return the floor carpet to the original condition and install the rear seat assembly (Refer to REAR SEAT ASSEMBLY ).
    G07047155Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals