Section 50 (Automatic Air Conditioning)
WARNING: This page is about a different car, the 2017 Mitsubishi Mirage. However, it is still accessible from the selected car via links, so may be relevant.
- General Description
- Service Specifications
- Automatic A/C Diagnosis
- Introduction
- Automatic Air Conditioning Troubleshooting Strategy
- Diagnostic Function
- Diagnostic Trouble Code Chart
- Diagnostic Trouble Code Procedures
- DTC B1001: Inside Temperature Sensor Low; Code No. B1002: Inside Temperature Sensor High
- DTC B1041: A/M Damper Potentiometer High; Code No. B1042: A/M Damper Potentiometer Low
- DTC B1045: Air Mix Damper Motor
- DTC B1061: Air Outlet Damper Potentio.High; Code No. B1062: Air Outlet Damper Potentio.Low
- DTC B1065: Air Outlet Changeover DMPR.Motor
- DTC B1083: EEPROM Fail
- DTC U1000: OSS/F. A. S. T._OSS CAN Timeout
- DTC U1100: Engine CAN Timeout
- DTC U1108: Meter CAN Timeout/Not Equipped
- DTC U1109: ETACS-ECU CAN Time-Out/Not Equipped
- DTC U1116: F. A. S. T. CAN Timeout/Not equipped
- DTC U1190: No Receive Fault Detect Signal
- DTC U1195: Coding Not Completed
- Trouble Symptom Chart
- Symptom Procedures
- INSPECTION PROCEDURE 1: Communication With The Scan Tool (M.U.T.-III) Is Not Possible
- INSPECTION PROCEDURE 2: Cool Air Does Not Come
- INSPECTION PROCEDURE 3: The Blower Does Not Work
- INSPECTION PROCEDURE 4: The Blower Air Volume Cannot Be Changed
- INSPECTION PROCEDURE 5: The Inside/Outside Air Changeover Is Impossible
- INSPECTION PROCEDURE 6: A/C Pressure Sensor System
- INSPECTION PROCEDURE 7: The A/C Compressor Does Not Work
- INSPECTION PROCEDURE 8: A/C-ECU Power Supply System
- Data List Reference Table
- Actuator Test Table
- Check At A/C-Ecu Terminals
- Special Tools
- Heater Control Unit
- Damper Control Motor Assembly
- Ambient Temperature Sensor
- Other Parts