Removal And Installation

CAUTION: When the knock sensor is replaced, initialize the learned value using scan tool (M.U.T.-III) (Refer to - Precautions before Service, INITIALIZATION PROCEDURE FOR LEARNING VALUE IN MFI ENGINE ).

Pre-removal Operation

Engine Room Under Cover Front Removal (Refer to - Under Cover - REMOVAL AND INSTALLATION ).
Oil Filter Removal (Refer to - On-vehicle Service, OIL FILTER REPLACEMENT ).
Oil Filter Cover Removal (Refer to - OIL PAN AND TIMING CHAIN CASE ).

Post-installation Operation

Oil Filter Cover Installation (Refer to - OIL PAN AND TIMING CHAIN CASE ).
Oil Filter Installation (Refer to - On-vehicle Service, OIL FILTER REPLACEMENT ).
Engine Room Under Cover Front Installation (Refer to - Under Cover -REMOVAL AND INSTALLATION ).

Fig 1: Removing/Installing Knock Sensor

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

For the removal and installation procedures, refer to - WATER HOSE AND PIPE ).

NOTES