Fuel Tank Differential Pressure Sensor Check
- Remove the second seat assembly (Refer to SECOND SEAT ASSEMBLY ), and turn up the floor carpet.
- Remove the floor inspection lid (LH).
- Disconnect the fuel tank differential pressure sensor connector.
- Connect special tool test harness set (MB991658) between the terminals of the disconnected connector.
- Turn the ignition switch to "ON" position and measure the voltage between terminal 1 and ground.
Standard value: 2.0 - 3.0 V
- If not within the standard value, replace the fuel tank differential pressure sensor.
- Connect the fuel tank differential pressure sensor connector.
- Install the inspection lid.
- Return the floor carpet to the original condition and install the second seat assembly (Refer to SECOND SEAT ASSEMBLY ).