Stop Light Switch Check
WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Do not apply lubricant (grease or silicon system sprayer etc.) to the switch and the switch installation section to avoid malfunction of the switch. In addition, do not use gloves which have lubricant (grease or silicon system sprayer etc.) on them.
Check for continuity between the terminals of the switch.
| Check condition | Terminal connector of tester | Normal condition |
|---|---|---|
| At free position | 1 - 2 (for stop light switch) | Continuity exists (2 Ω or less) |
| 3 - 4 (for cruise control) | No continuity | |
| Press the plunger from the edge of the outer case by the dimension shown in the figure. | 1 - 2 (for stop light switch) | No continuity |
| 3 - 4 (for cruise control) | Continuity exists (2 Ω or less) |