Section 100 (MITSUBISHI Multi-Communication System (MMCS) - With Diagnostics)
WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
- Special Tools
- MMCS Diagnosis
- Standard Flow Of Diagnostic Troubleshooting
- Precautions On Servicing MMCS
- Error Message
- Service Mode
- How To Initiate The Service Mode
- How To Terminate The Service Mode
- Service Mode Item
- Notes
- Present Position Revision
- Unit Diagnosis
- Communications & Connection Check
- Key Check
- Vehicle Signal Check
- SD Card Check
- Speaker Check
- Sensor Check
- Monitor Adjustment
- Monitor Check
- Touch Switch Confirmation
- Touch Switch Revision
- Camera Setting
- Log Function
- Output Log File (Navi)
- Telematics Log
- Service Data Log
- Versions Indication
- GPS Time Setting
- CAN Function Check
- Hands Free Module < Vehicles With Hands Free Ecu >
- Diagnostic Trouble Code Table
- Diagnostic Trouble Code Procedures
- Symptom Procedures
- Inspection Procedure 1: No navigation screen is displayed
- Inspection Procedure 2: No sound is heard. < Vehicles without audio amplifier >
- Inspection Procedure 2: No sound is heard. < Vehicles with audio amplifier >
- Inspection Procedure 3: The screen is not normal in the navigation mode. (The own vehicle mark is dislocated.)
- Inspection Procedure 4: The radio broadcasting can not be received. < Analog radio >
- Inspection Procedure 5: GPS signal cannot be received
- Inspection Procedure 6: CD cannot be played
- Inspection Procedure 7: SD card cannot be read
- Inspection Procedure 8: Power supply or communication circuit to the CAN box unit is defective
- Main Unit Terminal Voltages
- MMCS