Section 146 (Hands Free Module)
WARNING: This page is about a different car, the 2013 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
- General Information
- Special Tools
- Diagnosis
- Introduction To Diagnosis
- Standard Flow Of Diagnostic Troubleshooting
- Diagnosis Function
- Diagnosis Mode < Vehicles With Radio And Cd Player >
- Diagnosis Mode < Vehicles With MMCS >
- Trouble Symptom Chart
- Symptom Procedures
- INSPECTION PROCEDURE 1: Check the hands free module power supply circuit
- INSPECTION PROCEDURE 2: The USB adapter data cannot be replayed. < Vehicles with radio and CD player >
- INSPECTION PROCEDURE 2: The USB adapter data cannot be replayed. < Vehicles with MMCS >
- INSPECTION PROCEDURE 3: When the speech switch is pressed, the voice information is output, but the voice recognition is not performed
- INSPECTION PROCEDURE 4: When the speech switch is pressed, the voice information is not output. < Vehicles with radio and CD player >
- INSPECTION PROCEDURE 4: When the speech switch is pressed, the voice information is not output. < Vehicles with MMCS >
- INSPECTION PROCEDURE 5: DIAGNOSIS MODE cannot be made an entry. < Vehicles with radio and CD player >
- INSPECTION PROCEDURE 6: DIAGNOSIS MODE cannot be made an entry. Mobile Phone item is not displayed on the INFOR screen of MMCS. < Vehicles with MMCS >
- INSPECTION PROCEDURE 7: Steering wheel voice control switch illumination does not come on
- Inspection Procedure 8: Voice guide "Unable to obtain vehicle speed. Please try again or contact your dealer for service" is sent from the speaker. < Vehicles with radio and CD player >
- Inspection Procedure 8:Voice guide "Unable to obtain vehicle speed. Please try again or contact your dealer for service" is sent from the speaker. < Vehicles with MMCS >
- On-Vehicle Service
- Inspection