LEMON Manuals
: Even more car manuals for everyone
Home
>>
Mitsubishi
>>
2012
>>
Outlander Sport ES, Standard Trans
>>
Repair and Diagnosis
>>
Engine Mechanical
>>
Intake System And Exhaust System
Intake System And Exhaust System
Expand All (for easy ctrl-f)
Collapse All
General Information
Service Specification
Intake And Exhaust Diagnosis
Introduction
Troubleshooting Strategy
Symptom Chart
Symptom Procedures
Inspection Procedure 1: Exhaust Leakage
Diagnosis
Inspection Procedure 2: Abnormal Noise
Diagnosis
Special Tools
Air Cleaner
Removal And Installation
Notes
Installation Service Point
>> A << Mass Airflow Sensor Installation
Intake Manifold
Removal And Installation
Notes
Installation Service Points
>> A << Intake Manifold/Protector Installation
>> B << Intake Manifold Stay Installation
>> C << O-Ring/Manifold Absolute Pressure Sensor/Evaporative Emission Purge Solenoid Installation
Inspection
Intake Manifold Check
Exhaust Manifold
Removal And Installation
Notes
Removal Service Point
<< A >> Exhaust Manifold Nut/Exhaust Manifold Washer/Exhaust Manifold/Exhaust Manifold Lower Cover Removal < AWD >
Installation Service Points
>> A << Exhaust Manifold/Exhaust Manifold Washer/Exhaust Manifold Nut Installation < Fwd >
>> A << Exhaust Manifold Lower Cover/Exhaust Manifold/Exhaust Manifold Washer/Exhaust Manifold Nut Installation < AWD >
>> B << Exhaust Manifold Bracket Installation
Inspection
Exhaust Manifold Check
Exhaust Pipe And Main Muffler
Removal And Installation
< FWD (Except vehicles for California emission regulation) >
< FWD (Vehicles for California emission regulation) >
< AWD >
Removal Service Points
<< A >> Linear Air-Fuel Ratio Sensor/Heated Oxygen Sensor (Rear) Removal
<< B >> Heated Oxygen Sensor (Rear)/Heated Oxygen Sensor (3RD) Removal
<< C >> Rivet Removal
Installation Service Points
>> A << Exhaust Tail Pipe Diffuser Installation
>> B << Rivet Installation
>> C << Heated Oxygen Sensor (Rear)/Heated Oxygen Sensor (3RD) Installation
>> D << Linear Air-Fuel Ratio Sensor/Heated Oxygen Sensor (Rear) Installation