LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2012 >> Outlander SE, AWD >> Repair and Diagnosis >> Maintenance >> Procedures >> General Information >> Maintenance Service >> 13. Transfer Oil (Check Oil Level And Condition/Change) >> Notes

13. Transfer Oil (Check Oil Level And Condition/Change): Notes

  1. Remove the filler plug and gasket.
  2. Check that the oil level is just below the lower edge of the filler plug hole.
  3. Check that the oil is not excessively foul and has moderate viscosity.
  4. Install the filler plug and new gasket, then tighten them to the specified torque.

    5. Tightening torque: 32 ± 2 N.m (24 ± 1 ft-lb) 

    Fig 1: Identifying Filler Plug And Drain Plug
    G05431351Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
    Fig 2: Identifying Filler Plug And Filler Plug Hole
    G06480808Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals