Steering Angle Check

CAUTION: After adjusting the steering angle, always perform calibration to make ABS/ASC-ECU learn the neutral position of the steering wheel sensor. (Refer to STEERING WHEEL SENSOR CALIBRATION ). < Vehicles with ASC >

Check that the wheel alignment is normal (Refer to FRONT WHEEL ALIGNMENT CHECK AND ADJUSTMENT ).

Fig 1: Placing Front Wheel On Turning Radius Gauge
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Place the front wheel on a turning radius gauge and measure the steering angle.

STANDARD VALUE

Inner wheel	40°50' ± 1°30' (Difference between right and left wheels must be 2°00' or less)
Outer wheel (reference value)	33°50'

Fig 2: Identifying Distance Between Edge Of Bellows Assembly Groove And Jam Nut

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

If not within the standard value, adjust the tie-rods (right and left), and repeat Steps 1 and 2.
If the measured value exceeds the standard range by performing Step 3, replace the steering gear and linkage assembly (Refer to POWER STEERING GEAR BOX AND LINKAGE ).