Combination Meter - Lancer
- General Information
- Special Tools
- Diagnosis
- Standard Flow Of Diagnostic Troubleshooting
- Diagnosis Function
- Diagnostic Trouble Code Chart
- Diagnostic Trouble Code Procedures
- DTC B1200: Malfunction Of Odometer
- DTC B1201: Abnormal Fuel Information - FWD
- DTC B1201: Abnormal Fuel Information - AWD
- DTC B1209: Test Mode
- DTC B2203: VIN Not Programmed
- DTC B2463: Sticking Of Rheostat Switch
- DTC B2464: The Sticking Of Meter Information Switch
- DTC B2465: Ignition Switch Signal Error
- DTC U0019: Bus Off (CAN-B)
- DTC U0100: Engine Control Module CAN Timeout
- DTC U0141: ETACS CAN Timeout
- DTC U0151: SRS-ECU CAN Timeout
- DTC U0154: Occupant Classification-ECU CAN Timeout
- DTC U0164: A/C/Heater Control Unit CAN Timeout
- DTC U0168: KOS-ECU Or WCM CAN Timeout
- DTC U0184: Audio CAN Timeout
- DTC U0245: Audio Visual Navigation Unit CAN Timeout
- DTC U1415: Coding Not Completed/Data Fail
- Trouble Symptom Chart
- Symptom Procedures
- Inspection Procedure 1: Power Supply Circuit Check
- Inspection Procedure 2: The Speedometer Does Not Work (The Other Meters Work)
- Inspection Procedure 3: The Tachometer Does Not Work (The Other Meters Work)
- Inspection Procedure 4: Tone Alarm Does Not Sound Normally
- Notes
- Technical Description (Comment)
- Notes
- Seat Belt Reminder Function
- Keyless Operation Key Reminder Tone Alarm Function (Vehicles With KOS)
- Ignition Key Reminder Tone Alarm Function (Vehicles Without KOS)
- Light Reminder Tone Alarm Function
- Door-Ajar Warning Tone Alarm Function
- Freeze Warning Tone Alarm
- Parking Brake Reminder Tone Alarm Function
- Multi Information Display Interrupt Display Tone Alarm
- Meter Information Switch Operation Tone Alarm
- Paddle Shift Cancel Tone Alarm, Theft-Alarm Function, ETACS-ECU Function Customize Tone Alarm, A/C Operation Tone Alarm, Audio Operation Tone Alarm
- Troubleshooting Hints
- Diagnosis
- Inspection Procedure 5: The Combination Meter Light Does Not Illuminate Normally Or The Multi Information Display Is Not Displayed Normally
- Inspection Procedure 6: The Multi Information Display Screen Cannot Be Changed With The Operation Of The Meter Information Switch
- Service Data
- Actuator Test Table - Vehicles Without Color Liquid Crystal Display
- Check Procedure For Each Multi Information Display Screen
- Other Screens
- Check At Ecu Terminals
- On-Vehicle Service
- Speedometer Check
- Tachometer Check
- Fuel Level Sensor Check
- Meter Information Switch Check
- Service Reminder Function Set
- Combination Meter