LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2012 >> Lancer Evolution MR >> Repair and Diagnosis >> General Information >> OBD-II Drive Cycles >> Drive Cycle Procedures >> 2011-12 OUTLANTER 3.0L >> Pattern 10 >> Test Procedure

Test Procedure

  1. Start the engine with all the accessories switched OFF.
  2. Drive the vehicle for 6 minutes at the following conditions. (During the monitor)
    • Vehicle speed: More than 50 km/h (31 mph)
    • Air flow rate: More than 10 g/sec.
    • Except fuel cut. The system is normal if engine coolant temperature will rise more than 77°C (171°F) within 6 minutes.
  3. Stop at safe place and turn the ignition switch to "LOCK" (OFF) position.
  4. Start the engine and do Steps 1 to 3 again.
  5. Confirm that the diagnostic trouble code (DTC) is not output.
scientia non olet · About LEMON Manuals