LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2012 >> Lancer Evolution GSR >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Supplemental Restraint System (SRS) - Lancer) >> SIDE-AIRBAG MODULE(S) - Except RALLIART >> Inspection >> Front Seatback Assembly With Side-Airbag Module Check

Front Seatback Assembly With Side-Airbag Module Check

WARNING: This page is about a different variant/trim than selected.
WARNING: Never attempt to measure the circuit resistance of the air bag module (squib), even if you are using the specified tester. If the circuit resistance is measured with a tester, accidental air bag deployment will result, and possible serious personal injury.
WARNING: If any improper part is found during the following inspection, replace the front seatback assembly with a new one. Dispose of the old one according to the specified procedure (Refer to UNDEPLOYED AIR BAG MODULE DISPOSAL  ).
  1. Check the air bag module deployment section for dents or deformation.
  2. Check the connector for damage, the terminals for deformation, and the harness for binding.
    Fig 1: Identifying Side-Airbag Module Deployment Section
    G05385073Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals