General Information - Except Lancer Evolution

• How To Use This Service Information
  • Maintenance, Repair And Servicing Explanations
  • On-Vehicle Service
  • Service Procedures
  • Definition Of Terms
    • Standard Value
    • Limit
    • Reference Value
    • Danger, Warning, And Caution
    • Tightening Torque Indication
    • Special Tool Note
    • Abbreviations
    • Explanation Of Service Information Contents
• Troubleshooting Guidelines
  • Verify The Complaint
  • Determine Possible Causes
  • Find The Problem
  • Repair The Problem
  • Verify The Repair
• How To Use Troubleshooting/Inspection Service Points
  • Troubleshooting Contents
    • Notes
    • 1. Standard Flow Of Diagnostic Troubleshooting
    • 2. System Operation And Symptom Verification Tests
    • 3. Diagnostic Function
    • 4. Diagnostic Trouble Code Chart
    • 5. Symptom Chart
    • 6. Diagnostic Trouble Code Procedures
    • 7. Symptom Procedures
    • 8. Service Data Reference Table
    • 9. Check At Ecu Terminals
      • Notes
      • Terminal Voltage Checks
      • Terminal Resistance And Continuity Checks
    • 10. Inspection Procedures Using An Oscilloscope
  • How To Use The Inspection Procedures
    • Notes
    • Harness Inspection
    • Measures To Take After Replacing The Ecu
  • Connector Measurement Service Points
    • Notes
    • If Inspecting With The Connector Connected < Waterproof Connectors >
    • If Inspecting With The Connector Connected < Ordinary (Non-Waterproof) Connectors >
    • If Inspecting With The Connector Disconnected
  • Connector Inspection Service Points
    • Visual Inspection
    • Connector Pin Inspection
    • Connector Engagement Inspection
  • How To Cope With Intermittent Malfunctions
    • Notes
    • To Cope With Intermittent Malfunction;
      • 1. Ask The Customer About The Malfunction
      • 2. Determine The Conditions From The Customer's Responses
      • 3. Use Simulation Test
      • 4. Verify The Intermittent Malfunction Is Eliminated
    • Simulation Tests
  • How To Treat Past Trouble
  • Inspection Service Points For A Blown Fuse
• Vehicle Identification
  • Vehicle Identification Number Plate < Lancer >
    • Vehicles Identification Number Location
    • Code Chart
    • Vehicle Identification Number List
      • Vehicles For USA
        • (For Federal Emission Regulation)
        • (For CALIFORNIA Emission Regulation)
      • Vehicles For PUERTO RICO, GUAM And SAIPAN
      • Vehicles For CANADA
      • Vehicles For MEXICO
  • Vehicle Identification Number Plate < Lancer SPORTBACK >
    • Vehicles Identification Number Location
    • Code Chart
    • Vehicle Identification Number List
      • Vehicles For USA
        • (For Federal Emission Regulation)
        • (For CALIFORNIA Emission Regulation)
      • Vehicles For PUERTO RICO
      • Vehicles For GUAM And SAIPAN
      • Vehicles For CANADA
  • Chassis Number
    • Notes
    • Chassis Number Code Chart
  • Vehicle Identification Code Plate
    • Notes
    • Code Chart
  • Tire And Loading Information Placard
  • Engine Model Stamping
• General Data And Specifications
  • General Data And Specifications < Lancer >
    • 2.0L Engine (Non-Turbo)
    • 2.0L Engine (Turbo)
    • 2.4L Engine
  • General Data And Specifications < Lancer SPORTBACK >
    • 2.0L Engine (Non-Turbo)
    • 2.0L Engine (Turbo)
    • 2.4L Engine
• Precautions Before Service
  • CAUTIONS FOR WORKING IN ENGINE COMPARTMENT (2.0L ENGINE Turbo)
  • Supplemental Restraint System (SRS)
  • Servicing Electrical System
  • How To Shift Lock Forced Release
    • Notes
    • < TC-SST >
    • < CVT >
  • Scan Tool (Multi Use Tester {M.U.T.-III} Sub Assembly)
  • How To Perform Vehicle Identification Number (VIN) Writing
    • Notes
    • Writing Procedure
    • VIN Writing Steps For WCM And Kos-Ecu
  • Coding List
    • Notes
    • Variant Coding
    • Engine Control Module Coding Data List
    • TC-SST-Ecu Coding Data List
    • ETACS-Ecu Coding Data List
    • Option Coding
      • Notes
      • List < Engine Control Module >
      • List < ETACS-Ecu >
  • Initialization Procedure For Learning Value In MFI Engine
    • Notes
    • Initialization Procedure
  • Engine Idling Learning Procedure
    • Purpose
    • Learning Procedure
    • Initialization Procedure For Throttle Actuator Control Motor
  • TIMING CHAIN LEARNED VALUE RESET (2.0L ENGINE Non-turbo, 2.4L ENGINE)
  • Battery Current Sensor Calibration (Non-Turbo)
    • Purpose
    • Learning Procedure
  • TIMING CHAIN MAINTENANCE (2.0 L ENGINE Turbo)
    • Notes
    • Learned Value Read&Save And Write Learned Value (Changed Ecu)
    • Learned Value Reset
    • Test/Limit Value Readout
  • Form-In-Place Gasket (FIPG)
    • Notes
    • Disassembly
    • Gasket Surface Cleaning
    • Application Procedure
  • Bolts And Nuts With Stabilizer For Coefficient Of Friction
  • Application Of Anti-Corrosion Agents And Undercoats
  • Vehicle Washing
• Towing And Hoisting
  • Wrecker Towing Recommendation
    • Front Towing Pickup < Fwd >
    • Front Towing Pickup < AWD >
    • Rear Towing Pickup
    • Towing When Keys Are Not Available
    • Safety Precautions
    • Lifting, Jacking Support Location
      • Floor Jack
    • Post Type
• Tightening Torque
  • Notes
  • Standard Bolt And Nut Tightening Torque
  • Flange Bolt And Nut Tightening Torque
• Lubrication And Maintenance
  • Notes
  • Maintenance Schedules
  • Severe Service
  • Engine Oil
  • Lubricants And Greases
  • Fuel Usage Statement
  • Gasoline Containing Alcohol
  • Gasoline Containing Methyl Tertiary Butyl Ether (MTBE)
  • Materials Added To Fuel
• Recommended Lubricants And Lubricant Capacities Table
  • Recommended Lubricants
  • Lubricant Capacity Table
  • Lubricant Selection
    • Engine Oil
      • Notes
      • OIL VISCOSITY (2.0L ENGINE Non-turbo, 2.4L ENGINE)
      • OIL VISCOSITY (2.0L ENGINE Turbo)
• Scheduled Maintenance Table
  • (2.0L Engine Non-Turbo, 2.4L Engine)
    • Scheduled Maintenance Service For Emission Control And Proper Vehicle Performance
    • General Maintenance Service For Proper Vehicle Performance
    • Scheduled Maintenance Under Severe Usage Conditions
  • (2.0L Engine Turbo)
    • Scheduled Maintenance Service For Emission Control And Proper Vehicle Performance
    • General Maintenance Service For Proper Vehicle Performance
    • Scheduled Maintenance Under Severe Usage Conditions
• Maintenance Service (2.0L Engine Non-Turbo, 2.4L Engine)
  • 1. Fuel System (Tank, Pipe Line And Connection, And Fuel Tank Filler Tube Cap)
    • Check For Leaks
  • 2. Fuel Hoses
    • Check Condition
  • 3. Air Cleaner Element
    • Replace
  • 4. Evaporative Emission Control System (Except Evaporative Emission Canister)
    • Check For Leaks And Clogging
  • 5. Spark Plugs (Iridium-Tipped Type)
    • Replace
  • 6. Intake And Exhaust Valve Clearance
    • Inspect And Adjust
  • 7. Drive Belt (For The Generator And Power Steering Oil Pump)
    • Check Condition
  • 8. Exhaust System (Connection Portion Of Muffler, Muffler Pipes And Converter Heat Shields)
    • Check And Service
  • 9. Engine Oil
    • Change
  • 10. Engine Oil Filter
    • Notes
    • Engine Oil Filter Selection
    • Oil Filter Replacement
  • 11. Transaxle Oil < M/T >
    • Check Oil Level And Condition Transaxle Oil Level Check
    • Transaxle Oil Replacement
  • 12. Transmission Fluid < CVT >
    • Check Oil Level And Condition
    • Transmission Fluid Change
  • 13. Engine Coolant
    • Change
  • 14. Coolant Hoses (Radiator Hose, Heater Hose)
    • Inspect
  • 15. Disk Brake Pads And Rotors
    • Inspect For Wear
      • Brake Pad Check
      • Brake Disc Thickness Check
      • Brake Disc Run-Out Check And Correction
  • 16. Rear Drum Brake Linings And Rear Wheel Cylinders
    • Inspect For Wear And Leaks
      • Brake Lining Thickness Check
      • Brake Drum Inside Diameter Check
      • Rear Wheel Cylinders Check
  • 17. Brake Hoses
    • Check For Deterioration Or Leaks
  • 18. Ball Joint And Steering Linkage Seals
    • Inspect For Grease Leaks And Damage
  • 19. Drive Shaft Boots
    • Inspect For Grease Leaks And Damage
  • 20. Suspension System
    • Inspect For Looseness And Damage
  • 21. Tires
    • Rotate
  • 22. Clean Air Filter
    • Replace
• Maintenance Service (2.0L Engine Turbo)
  • 1. Fuel System (Tank, Pipe Line And Connection, And Fuel Tank Filler Tube Cap)
    • Check For Leaks
  • 2. Fuel Hoses
    • Check Condition
  • 3. Air Cleaner Element
    • Replace
  • 4. Evaporative Emission Control System (Except Evaporative Emission Canister)
    • Check For Leaks And Clogging
  • 5. Spark Plugs (Iridium-Tipped Type)
    • Replace
  • 6. Intake And Exhaust Valve Clearance
    • Inspect And Adjust
  • 7. Drive Belt (For The Generator And Power Steering Oil Pump)
    • Replace
  • 8. Exhaust System (Connections Portion Of Muffler, Muffler Pipes And Converter Heat Shields)
    • Check And Service
  • 9. Engine Oil
    • Change
  • 10. Engine Oil Filter
    • Notes
    • Engine Oil Filter Selection
    • Oil Filter Replacement
  • 11. Twin Clutch-SPORTRONIC Shift Transmission (TC-SST) Fluid
    • Check Fluid Leaks (If Necessary, Check The Oil Level)
      • Transmission Fluid Leakage Check
      • Transmission Fluid Level Check
      • Transmission Fluid Change
  • 12. Twin Clutch-SPORTRONIC Shift Transmission (TC-SST) Oil Filter
    • Change
  • 13. Transfer Oil (With Active Center Differential)
    • Check Oil Level
    • Oil Change
  • 14. Reserve Tank Fluid (For Active Center Differential)
    • Check Fluid Level
      • < When The Scan Tool Is Not Used >
      • < When The Scan Tool Is Used >
  • 15. Engine Coolant
  • 16. Coolant Hoses (Radiator Hose And Heater Hose)
    • Inspect
  • 17. Disk Brake Pads And Rotors
    • Inspect For Wear
      • Brake Pads Check
      • Brake Disc Thickness Check
      • Brake Disc Run-Out Check And Correction
  • 18. Brake Hoses
    • Check For Deterioration Or Leaks
  • 19. Ball Joint And Steering Linkage Seals
    • Inspect For Grease Leaks And Damage
  • 20. Drive Shaft Boots
    • Inspect For Grease Leaks And Damage
  • 21. Suspension System
    • Inspect For Looseness And Damage
  • 22. Rear Axle Oil (With Limited Slip Differential)
    • Change
  • 23. Tires
    • Rotate
  • 24. Clean Air Filter
    • Replace
• Main Sealant And Adhesive Table