LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2011 >> Endeavor SE, FWD >> Repair and Diagnosis >> Brakes >> Traction Control >> Traction Control System (TCL) >> On-Vehicle Service >> TCL Switch Check

TCL Switch Check

  1. Remove the TCL switch. (Refer to TCL SWITCH  ).
  2. Measure the resistance between terminal 1 and terminal 2 when the TCL switch is pressed or released. If the values measured at the time correspond to those in the table below, the resistance values are correct.
    SWITCH SPECIFICATION

    SWITCH POSITION TESTER CONNECTION SPECIFIED CONDITION
    Pressed 1 - 2 Continuity (Less than 2 ohms)
    Released 1 - 2 Open circuit
    Fig 1: Identifying TCL Switch Connector
    G06699145Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals