Multi-Center Display
- General Description
- Special Tools
- Diagnosis
- Multi-Center Display Diagnostic Trouble Code Diagnosis
- Diagnosis Function
- Diagnostic Trouble Code Chart
- Diagnostic Trouble Code Procedures
- DTC 010: Bus Off
- DTC 011: Powertrain Control Module Time-out (Related to Engine); DTC 012: Powertrain Control Module Time-out (Related to A/T)
- DTC 013: A/C-ECU Time-out
- DTC 014: Combination Meter Time-out
- DTC 019: ETACS-ECU Time-out
- DTC 020: Failures Information on Powertrain Control Module (Related to Engine)
- DTC 021: Failures Information on Combination Meter
- DTC 022: Failures Information on A/C-ECU
- DTC U1073: Bus Off
- DTC U1100: Powertrain Control Module Time-out (Related to Engine)
- DTC U1108: Combination meter time-out
- DTC U1109: ETACS-ECU Time-out
- DTC U1110: A/C-ECU time-out
- DTC U1120: Failure Information on Powertrain Control Module (Related to Engine)
- DTC U1128: Failure information on combination meter
- DTC U1130: Failure information on A/C-ECU
- DTC U1606: M-BUS error
- Symptom Chart
- Equipment Diagnosis
- INSPECTION PROCEDURE 1:Communication with Scan Tool Is not Possible. (Middle Grade Type)
- INSPECTION PROCEDURE 2: The Multi-Center Display does not Show Any Information. (Middle Grade Type)
- INSPECTION PROCEDURE 3: The Multi-center Display does not Show any Information. (Low Grade type)
- INSPECTION PROCEDURE 4: The A/C Display Shows "COMMUNICATION ERROR", and then can not Proceed to Next Screen. (Middle Grade Type or Vehicles With Mitsubishi Multi Communication System)
- INSPECTION PROCEDURE 5: The Ambient Air Temperature Display Shows "COM ERROR" or "-°C (-°F)." (Middle Grade Type or Vehicles With Mitsubishi Multi Communication System)
- INSPECTION PROCEDURE 6: On the Audio Screen, "COMMUNICATION ERROR" can not Proceed to Next Screen. (Middle Grade Type)
- INSPECTION PROCEDURE 7: The compass needle deviates easily. Or, the compass does not work normally even when the compass calibration is performed manually. (Middle Grade Type)
- On-Vehicle Service
- Multi-Center Display
- Multi-Center Display Bulb Removal