Section 5 (Electronic Control AWD)
WARNING: This page is about a different variant/trim than selected.
- General Information
- Service Precautions
- Service Specifications
- Sealant
- Special Tools
- Diagnosis
- Standard Flow Of Diagnostic Troubleshooting
- Precautions For Diagnosis
- Check Of Drive Mode Indicators (4WD/Lock)
- Diagnostic Function
- Freeze Frame Data Reference Table
- Diagnosis Code Table
- Diagnostic Trouble Code Procedures
- DTC C1078: Tire With Incorrect Diameter Equipped
- DTC C1456: Wiring Harness Or Coupling Coil Overcurrent Failure
- DTC C145A: Wiring Harness and Coupling Coil Short Circuit Failure
- DTC C145D: Wiring Harness And Coupling Coil Open Circuit Failure
- DTC C145F: Coupling Overload
- DTC C1460: Drive Mode Selector Circuit Failure
- DTC C2100: Abnormal Battery Voltage (Too Low)
- DTC C2101: Abnormal Battery Voltage (Too High)
- DTC C211C: Abnormal IG1 Power Supply Low Voltage
- DTC C211D: Abnormal IG1 Power Supply High Voltage
- DTC C211E: Abnormal Power Supply Voltage (Too Low)
- DTC C211F: Abnormal Power Supply Voltage (Too High)
- DTC C2208: AWD-ECU Internal Error
- DTC U0001: Bus-Off Error
- DTC U0100: Engine CAN Time-Out
- DTC U0121: ABS CAN Time-Out
- DTC U0141: ETACS CAN Time-Out
- DTC U0401: Engine CAN Data Error
- DTC U0415: ABS CAN Data Error
- DTC U113C: Wheel Speed Sensor Data Error
- Trouble Symptom Table
- Symptom Procedures
- Inspection Procedure 1: Scan Tool MB991958 Cannot Communicate With the Electronic Control AWD System
- Inspection Procedure 2: The Switch Position of the Drive Mode Selector Does Not Match With the Indicator Display in the Combination Meter
- Inspection Procedure 3: The Tight Corner Braking Phenomenon* Appears with the Drive Mode Selector in the FWD or AWD Position
- Inspection Procedure 4: No DTC Is Set Even When the AWD/LOCK Indicator Lights Flash
- Data List Reference Table
- Actuator Test Table
- Check At Ecu Terminals
- On-Vehicle Service
- AWD-Ecu
- Drive Mode Selector
- Electronic Control Coupling