Map Sensor - Installation - 3.7L

Fig 1: MAP SENSOR O-RING 3.7L / 4.7L

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Clean MAP sensor mounting hole at intake manifold.
Check MAP sensor o-ring seal (2) for cuts or tears.

Fig 2: MAP SENSOR O-RING 3.7L / 4.7L
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Position MAP sensor into manifold by sliding sensor over locating pin (6).
Install mounting bolt (8). Tighten to 3 N.m (25 in. lbs.) torque.
Connect electrical connector (2).