Steering Angle Check

CAUTION: After adjusting the steering angle, always perform calibration to make ABS/ASC-ECU learn the neutral position of the steering wheel sensor. Refer to STEERING WHEEL SENSOR CALIBRATION < Vehicles with ASC >

Check that the wheel alignment is normal.

Place the front wheel on a turning radius gauge and measure the steering angle.

Standard value:

ITEM SPECIFICATIONS CHART

Item	Specifications
Inside wheel	38°40' ± 1°30'
Outside wheel (reference value)	32°20'

Fig 1: Measuring Steering Angle

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

If not within the standard value, adjust the tie-rods (right and left), and repeat Steps 1 and 2.
If the measured value exceeds the standard range by performing Step 3, replace the steering gear and linkage assembly.

Fig 2: Identifying Tie-Rod Lock Nut And End Of Bellows Assembly Groove
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.