Body - Lancer
- Hood
- Fender
- Splash Shield
- Fuel Filler Lid
- Strut Tower Bar
- Window Glass
- Door
- Service Specifications
- Sealant
- Component Identifications
- General Information
- Central Door Locking System Diagnosis
- INSPECTION PROCEDURE 1: Central Door Locking System does not work at All.
- INSPECTION PROCEDURE 2: A Door cannot be Locked or Unlocked by The Central Door Locking System.
- Notes
- Circuit Operation
- Technical Description (Comment)
- Troubleshooting Hints
- Diagnostic Procedure
- INSPECTION PROCEDURE 3: Selector "P" Position-linked Door Unlock Function does not Operate Normally. <Vehicles with CVT with Keyless Entry System>
- Operation
- Diagnosis Procedure
- Power Window Diagnosis
- Diagnostic Trouble Code Chart
- Trouble Symptom Chart
- Diagnostic Trouble Code Procedures
- CODE NO. L0730 P/W (DR) SW pulse 1 disconnection
- Comments On Trouble Symptom
- Probable Causes
- Diagnostic Procedure
- CODE NO. L0732 P/W (DR) SW pulse 2 disconnection
- CODE NO. L0734 P/W (DR) Above window position
- CODE NO. L0736 P/W (DR) Sensor fail (ground)
- CODE NO. L0740 P/W (DR) 3 times jam - protection
- CODE NO. L0746 P/W (DR) Parameter read fail; CODE NO. L0750 P/W (DR) Position read fail
- INSPECTION PROCEDURE 1: Power Windows do not work at All.
- INSPECTION PROCEDURE 1: Power Windows do not work at All.
- INSPECTION PROCEDURE 2: Driver's Power Window does not work by means of The Power Window Main Switch.
- INSPECTION PROCEDURE 2: Driver's Power Window does not work by means of The Power Window Main Switch.
- INSPECTION PROCEDURE 3: Relevant Power Window(s) does not work by means of THe Front and Rear Passenger's Power Window Sub Switches.
- INSPECTION PROCEDURE 3: Relevant Power Window(s) does not work by means of The Front and Rear Passenger's Power Window Sub Switches.
- INSPECTION PROCEDURE 4: Front and/or Rear Passenger's Power Window(s) do not work by means of The Power Window Main Switch.
- INSPECTION PROCEDURE 4: Front and/or Rear Passenger's Power Window(s) do not work by means of The Power Window Main Switch.
- INSPECTION PROCEDURE 5: The Power Window Timer Function does not work Normally.
- INSPECTION PROCEDURE 6: Power Window Anti-trap Function does not work Normally.
- INSPECTION PROCEDURE 7: The Window Glass Lowers Automatically while it is Rising.
- Door Diagnosis
- INSPECTION PROCEDURE 1: Water Leak Through Door Window Glass
- Diagnosis
- INSPECTION PROCEDURE 2: Door Window Glass Malfunction
- INSPECTION PROCEDURE 3: Water Leak Through Door Edge
- INSPECTION PROCEDURE 4: Water Leak from Door Center
- INSPECTION PROCEDURE 5: Door Hard to Open
- INSPECTION PROCEDURE 6: Door does not Open or Close Completely
- INSPECTION PROCEDURE 7: Uneven Gap Between Body
- INSPECTION PROCEDURE 8: Wind Noise Around Door
- How To Locate Wind Noise
- Special Tools
- On-Vehicle Service
- Door Fit Adjustment
- Door Window Glass Adjustment
- Power Window Check
- Glass Sliding Mechanism Check And Adjustment
- POWER WINDOW SAFETY MECHANISM CHECK <Vehicles with auto down and auto up mechanism (driver's side)>
- Power Window Timer Function Check
- Power Window Operating Current Check
- LEARNING PROCEDURES OF THE POWER WINDOW FULLY CLOSED POSITION
- Central Door Locking System Check
- Check Of Key Lock Prevention Function
- Shift "P" Interlink Door Unlock Function Check
- Door Outside Handle Play Check
- Door Inside Handle Check
- Customize Function
- Door Assembly
- Door Glass And Regulator
- Door Handle And Latch
- Removal And Installation
- Inspection
- Window Glass RUNCHANNEL And Door Opening Weatherstrip Removal And Installation
- PROTECTOR FILM
- Trunk Lid
- Sunroof
- Specifications
- Sunroof Diagnosis
- INSPECTION PROCEDURE 1: Sunroof does not work at All.
- INSPECTION PROCEDURE 2: The Sunroof Lid Glass does not Tilt-up (Tilt-down, Open, and Close Normally).
- INSPECTION PROCEDURE 3: The Sunroof Lid Glass does not Open (Tilt-up, Tilt-down, And Close Normally).
- INSPECTION PROCEDURE 4: The Sunroof Lid Glass does not Tilt-down or Close (Tilt-up and Open Normally).
- INSPECTION PROCEDURE 5: Sunroof Safety Function does not work Normally.
- INSPECTION PROCEDURE 6: The Sunroof Timer Function does not work.
- Special Tools
- On-Vehicle Service
- Sunroof
- Loose Panel