LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2007 >> Raider SE >> Repair and Diagnosis >> Transmission >> Automatic Trans >> 545RFE - Service Information >> Sensor - Output Speed >> Installation

Sensor - Output Speed: Installation

  1. Install the output speed sensor (1) into the transmission case.
  2. Install the bolt to hold the output speed sensor (1) into the transmission case. Tighten the bolt to 12 N.m (105 in.lbs.).
  3. Install the wiring connector onto the output speed sensor (1).
  4. Verify the transmission fluid level. Add fluid as necessary.
  5. Lower vehicle.
    Fig 1: Identifying Input And Output Speed Sensors And Line Pressure Sensor
    G04856020Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals