LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2007 >> Raider SE >> Repair and Diagnosis >> Engine Performance >> Ignition System >> Engine Electrical >> Starter >> Installation >> 3.7L /4.7L With Auto. Trans.

3.7L /4.7L With Auto. Trans.

Fig 1: Removing/Installing Starter - 3.7L /4.7L With A/T
G04854963Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  1. Connect solenoid wire to starter motor (snaps on).
  2. Position battery cable (1) to solenoid stud. Install and tighten battery cable eyelet nut (2). Refer to TORQUE SPECIFICATIONS . Do not allow starter motor to hang from wire harness.
  3. Position starter motor (4) to transmission.
  4. If equipped with automatic transmission, slide cooler tube bracket into position.
  5. Install and tighten both bolts (3). Refer to TORQUE SPECIFICATIONS .
  6. Lower vehicle.
  7. Connect negative battery cable.
scientia non olet · About LEMON Manuals