LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2007 >> Raider DuroCross >> Repair and Diagnosis >> Transmission >> Automatic Trans >> 42RLE - Service Information >> Sensor - Input Speed >> Installation

Sensor - Input Speed: Installation

Fig 1: Identifying Input And Output Speed Sensors And Transmission Range Sensor
G04855605Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  1. Install the input speed sensor (1) into the transmission case.
    NOTE: Before installing the speed sensor bolt, it will be necessary to replenish the sealing patch on the bolt using Loctite 242 Lock & Seal Adhesive or equivalent.
  2. Install the bolt to hold the input speed sensor into the transmission case. Tighten the bolt to 9 N.m (80 in. lbs.).
  3. Install the wiring connector onto the input speed sensor
  4. Verify the transmission fluid level. Add fluid as necessary.
  5. Lower vehicle.
scientia non olet · About LEMON Manuals