Specifications Index
RAIDER SPECIFICATIONS INDEX
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Axle Nut/Hub Nut | |||
| Front | NA | ||
| Rear | NA | ||
| Battery | BATTERY | ||
| Brakes | |||
| Bleeding Sequence | STANDARD PROCEDURE | ||
| Disc Brakes | |||
| Service Specifications | BASE BRAKE SPECIFICATIONS | ||
| Torque | TORQUE CHART . | ||
| Drum Brakes (Parking Brake) | |||
| Service Specifications | Refer to BASE BRAKE SPECIFICATIONS . | ||
| Torque | TORQUE CHART . | ||
| Charging | |||
| Generator | SPECIFICATIONS | ||
| Torque | TORQUE - CHARGING SYSTEM | ||
| Drive Belts | |||
| Adjustment | ACCESSORY DRIVE BELT | ||
| Belt Routing | ACCESSORY DRIVE BELT | ||
| Engine Cooling | |||
| General Service Specifications | SPECIFICATIONS | ||
| Radiator Cap Pressure | Standard value: 131 to 158 kPa (19 to 23 psi). | ||
| Thermostat R & I | REMOVAL- 3.7L/4.7L ENGINE and INSTALLATION- 3.7L/4.7L ENGINE | ||
| Water Pump R & I | REMOVAL - 3.7L/4.7L ENGINE and INSTALLATION - 3.7/4.7L ENGINE | ||
| Engine Mechanical | |||
| 3.7L | |||
| Compression | Standard value : 1,172-1,551 kPa (170-225 psi). | ||
| Oil Pressure | At curb idle is 25 kPa (4 psi) or more. At 3,000 r/min: 170 - 758 kPa (25 - 110 psi). |
||
| Overhaul | SPECIFICATIONS - 3.7L ENGINE | ||
| Torque | TORQUE | ||
| 4.7L | |||
| Compression | NA | ||
| Oil pressure | At curb idle: 48 kPa (7 psi) or more At 3,000 r/min: 240 - 725 kPa (35 - 105 psi) |
||
| Overhaul | SPECIFICATIONS - 4.7L ENGINE | ||
| Torque | TORQUE | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Flex Plate/Drive Plate (Bolt) | |||
| 3.7L | 95 N.m (70 ft-lb) | ||
| 4.7L | 60 N.m (45 ft-lb) | ||
| Fuel System | |||
| Pressure Specification | NA | ||
| Fuel Pressure Test Procedure | FUEL SYSTEM PRESSURE RELEASE | ||
| Fuel Filter Location | MODULE - FUEL PUMP / | ||
| Fuel Filter R & I | MODULE - FUEL PUMP / | ||
| Ignition | |||
| Firing Order & Cylinder Identification | |||
| 3.7L | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| 4.7L | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | SPARK PLUG INSULATION RESISTANCE CHECK | ||
| Ignition Wires (Routing) | |||
| 3.7L | NA | ||
| 4.7L | NA | ||
| Spark Plug | |||
| 3.7L | |||
| Type | NA | ||
| Gap | NA | ||
| Torque | NA | ||
| 4.7L | |||
| Type | NA | ||
| Gap | NA | ||
| Torque | NA | ||
| Starting | |||
| Starter | SPECIFICATIONS | ||
| Torque | SPECIFICATIONS - TORQUE - STARTING SYSTEM | ||
| Wheel Alignment | |||
| Adjustment Specifications | |||
| Front | NA | ||
| Rear | NA | ||
| Torque | |||
| Front | TORQUE SPECIFICATIONS | ||
| Rear | TORQUE SPECIFICATIONS | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 135-10 ft. lbs (183-10 N.m) | ||