Front Suspension & Wheel Alignment- Lancer Evolution

• General Description
  • Notes
  • Features (Compared To The Lancer)
    • Inverted Struts
    • Coil Springs
    • Lower Arm Assembly
    • Stabilizer
    • CROSSMEMBER
    • Strut Insulator
    • Alignment
  • Construction Diagram
• Front Suspension Diagnosis
  • Introduction To Front Suspension Diagnosis
  • Front Suspension Diagnosis Troubleshooting Strategy
  • Symptom Chart
  • Symptom Procedures
    • INSPECTION PROCEDURE 1: Steering Wheel Is Heavy, Vibrates or Pulls to One Side
      • Diagnosis
    • INSPECTION PROCEDURE 2: Excessive Body Rolling
      • Diagnosis
    • INSPECTION PROCEDURE 3: Poor Ride
      • Diagnosis
    • INSPECTION PROCEDURE 4: Unequal Ride Height
      • Diagnosis
    • INSPECTION PROCEDURE 5: Noise
      • Diagnosis
• Special Tools
• On-Vehicle Service
  • Front Wheel Alignment Check And Adjustment
    • Notes
    • Toe-In
    • Camber, Caster And Kingpin Inclination
    • Selection The Camber
  • Lower Arm Ball Joint End Play Check
  • Ball Joint Dust Cover Check
• Strut Assembly
  • Removal And Installation
  • Inspection
  • Disassembly And Assembly
    • Notes
    • Disassembly Service Points
      • << A >> Strut Nut Removal
      • << B >> Front Suspension Strut Removal
    • Assembly Service Points
      • >> A << Strut Nut Installation
• Lower Arm
  • Removal And Installation
    • Notes
    • Removal Service Point
      • << A >> Lower Arm And CROSSMEMBER Disconnection
  • Inspection
    • Notes
    • Lower Arm Ball Joint Breakaway Torque Check
    • Pillow Ball Bushing Breakaway Torque Check
    • Lower Arm Ball Joint Dust Cover Check
  • Ball Joint Dust Cover Replacement
  • Lower Arm Pillow Ball Bushing Replacement
• Stabilizer Bar
  • Removal And Installation
    • Notes
    • Removal Service Points
      • << A >> Tie Rod End And Knuckle Disconnection
      • << B >> Stabilizer Bracket/Stabilizer Bushing/Stabilizer Bar Removal
    • Installation Service Points
      • >> A << Stabilizer Bar/Stabilizer Bushing/Stabilizer Bracket Installation
  • Inspection
    • Notes
    • Stabilizer Link Ball Joint Turning Torque Check
    • Stabilizer Link Ball Joint Dust Cover Check
• CROSSMEMBER Bar
  • Removal And Installation
• Specifications
  • Fastener Tightening Specifications
  • General Specifications
    • Coil Spring
  • Service Specifications