Pulse Check
- The input signals (signals other than SWS communication line signals), which are compatible with the SWS monitor by using the scan tool or voltmeter, can be confirmed by the Pulse Check.
- Use the scan tool or voltmeter to check the following input signals.NOTE: If a problem is found the Pulse Check, proceed to the Problems during Input Signal Check < Scan tool or voltmeter > (Refer to SWS MONITOR ).
Switches and their conditions, which are applicable for Pulse Check
INPUT SIGNALS INSPECTION CHART
| INPUT SIGNAL | REQUIREMENTS FOR SOUNDING TONE ALARM | |
|---|---|---|
| Key reminder switch | When the inserted ignition key is pulled out. | |
| Hazard warning light switch | When the switch is turned from off to on. | |
| Seat belt switch | When the seat belt is fastened. | |
| All door switches (except front door switch) | Either of the doors (except front door) is opened. | |
| Door lock key cylinder switch | When the door lock key cylinder is locked or unlocked. | |
| Driver's door lock actuator | When the driver's key cylinder or inside lock knob is unlocked. | |
| Door lock switch | When a door is locked or unlocked by a door lock switch. | |
| Vehicle speed sensor signal | When the vehicle speed reaches 10 km/h or more. | |
| Keyless entry system transmitter | Lock and/or unlock switch | When lock and/or unlock switch is turned from off to on. |
| Receive a interior light loaded signal | Illuminate any of the interior lights. | |