Section 6 (Overhaul (F4A4B))
WARNING: This page is about a different variant/trim than selected.
- General Description
- Special Tools
- Transaxle
- Oil Pump
- UNDERDRIVE Clutch And Input Shaft
- Reverse And Overdrive Clutch
- Disassembly And Assembly
- Number Of Clutch Discs And Plates
- Disassembly Service Point
- Assembly Service Points
- >> A << D-Ring Installation
- >> B << Reverse Clutch Piston Installation
- >> C << Snap Ring Installation
- >> D << Pressure Plate/Clutch Plate/Clutch Disc/Clutch Reaction Plate Installation
- >> E << Snap Ring Installation
- >> F << Clutch Plate/Clutch Disc/Clutch Reaction Plate Installation
- >> G << Snap Ring Installation
- Disassembly And Assembly
- Planetary Gear
- Low-Reverse Brake
- Second Brake
- Output Shaft
- Differential
- Valve Body
- Drive Shaft Oil Seal
- Specifications
- Fastener Tightening Specifications
- General Specifications
- Service Specifications
- Valve Body Spring Identification Table
- Adjusting Plate, Snap Ring And Spacers
- Thrust washer (For adjustment of input shaft end play)
- Snap ring (For adjustment of underdrive clutch and overdrive clutch end play)
- Snap ring (For adjustment of low-reverse brake and second brake reaction plates end play)
- Pressure plate (For adjustment of low-reverse brake and second brake end play)
- Snap ring (For adjustment of reverse clutch end play)
- Snap ring (For adjustment of reverse clutch and overdrive clutch spring retainer end plays)
- Thrust race (For adjustment of underdrive sun gear end play)
- Spacer (For adjustment of output shaft preload)
- Spacer (For adjustment of differential case preload)
- Spacer (For adjustment of backlash between differential side gear and pinion
- Sealants