Section 19 (Traction Control System (TCL))
WARNING: This page is about a different car, the 2005 Mitsubishi Endeavor. However, it is still accessible from the selected car via links, so may be relevant.
- General Description
- Traction Control System (TCL) Diagnosis
- Introduction To Traction Control System (TCL) Diagnosis
- Diagnostic Troubleshooting Strategy
- Diagnosis Function
- Diagnostic Trouble Code Chart
- Diagnostic Trouble Code Procedures
- C1396: Engine Torque Intervention Refusal
- C1397: Transmission Range Switch Input Refusal
- U1100: CAN Communications System Time Out Error Engine Related Data
- U1101: CAN Communications System Time Out Error A/T Related Data
- U1120: CAN Communications System TCL Uncontrollable by Engine Malfunction
- U1400: Dynamic range error APS1
- Symptom Chart
- Symptom Procedures
- INSPECTION PROCEDURE 1: When the Ignition Switch is Turned to the "ON" Position (Engine Stopped), the "TCL OFF" Indicator Light does not Illuminate. INSPECTION PROCEDURE 2: When the Ignition Switch is Turned to the "ON" Position (Engine Stopped), the TCL Work Indicator Light does not Illuminate. INSPECTION PROCEDURE 3: The "TCL OFF" Indicator Light Remains Illuminated After the Engine is Started. INSPECTION PROCEDURE 4: The TCL Work Indicator Light Remains Illuminated After the Engine is Started.
- INSPECTION PROCEDURE 5: When the TCL Switch is Push On, TCL does not Cancelled.
- INSPECTION PROCEDURE 6: TCL does not Operate.
- Data List Reference Table
- Actuator Test Reference Table
- Check At Abs/TCL-Ecu Terminal Voltage
- Check At TCL/ASC-Ecu Terminal Voltage
- Special Tools
- On-Vehicle Service
- TCL Switch
- Wheel Speed Sensor
- Abs/TCL-Ecu