Individual Component Service
WARNING:
- If heat damage may occur during paint work, remove the SRS-ECU, the air bag modules, the clock spring, the front seats and the seat belt with pre-tensioner. Recheck the SRS system operability after reinstalling them (Refer to 22. SRS AIR BAG (INSPECT FOR SRS SYSTEM)
).
- SRS-ECU, air bag module, clock spring, front impact sensor, side impact sensor: 93° C (200° F) or more
- Seat belt with pre-tensioner: 90 °C (194 °F) or more
- If the SRS components are removed for the purpose of check, sheet metal repair, painting, etc, they should be stored in a clean, dry place until they are reinstalled.
If the SRS components are to be removed or replaced as a result of maintenance, diagnosis, etc., follow the appropriate procedure in this article ( FRONT IMPACT SENSORS , REMOVAL AND INSTALLATION , AIR BAG MODULES AND CLOCK SPRING , SIDE IMPACT SENSOR , SEAT BELT WITH PRE-TENSIONER ).