Individual Component Service
WARNING:
- If heat damage occurs during paint work, remove the SRS-ECU, the air bag modules, the clock spring, front seats, and the seat belt with pre-tensioner. Recheck the SRS system operability after reinstalling them. (Refer to 22. SRS AIR BAG (INSPECT FOR SRS SYSTEM)
).
- SRS-ECU, air bag module, clock spring: 93°C (200°F) or more
- Seat belt with pre-tensioner: 90°C (194°F) or more
- If the SRS components are removed for the purpose of inspection, sheet metal repair, painting, etc., they should be stored in a clean, dry place until they are reinstalled.
If the SRS components are to be removed or replaced as a result of maintenance, diagnosis, etc., follow the appropriate procedure in this section. (Front impact sensor: Refer to FRONT IMPACT SENSORS , SRS-ECU: Refer to SRS CONTROL UNIT (SRS-ECU) , Air bag modules and clock spring: Refer to AIR BAG MODULES AND CLOCK SPRING , Side impact sensor: Refer to SIDE IMPACT SENSOR , Seat belt with pre-tensioner: Refer to SEAT BELTS WITH PRE-TENSIONER ).