Individual Component Service
WARNING:
- The SRS components should not be subjected to heat over 93°C (200 °F), so remove the SRS-ECU, air bag modules (driver's side and front passenger's side), front seat assemblies (side air back module), clock spring, side impact sensors before drying or baking the vehicle after painting. Recheck the SRS system operability after reinstalling them (Refer to 22. SRS AIR BAG (INSPECT FOR SRS SYSTEM) ).
- If the SRS components are removed for the purpose of checking, sheet metal repair, painting, etc., they should be stored in a clean, dry place until they are reinstalled.
If the SRS components are to be removed or replaced as a result of maintenance, diagnosis, etc., follow the appropriate procedure in this section (SRS Air Bag Control Unit: Refer to HARNESS CONNECTOR , Air Bag Modules and Clock Spring: Refer to INSPECTION , Side impact sensors: Refer to SIDE IMPACT SENSOR ).