LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2004 >> Outlander LS, AWD >> Repair and Diagnosis >> Suspension >> Front Suspension >> On-Vehicle Service >> Front Wheel Alignment Check And Adjustment >> Toe-In

Front Wheel Alignment Check And Adjustment: Toe-In

  1. Adjust the toe-in by undoing the clip and jam nut, and turning the left and right tie rod turnbuckles by the same amount (in opposite directions).
    NOTE: The toe will move out as the left turnbuckle is turned toward the front of the vehicle and the right turnbuckle is turned toward the rear of the vehicle.

    Standard value: 1 +/- 2 mm (0.04 +/- 0.09 Inch) 

    Fig 1: Adjusting Toe-In By Undoing Clip And Jam Nut
    G00746146Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Install the clip and tighten the jam nut to the specified torque.

    Tightening torque: 52 +/- 2 N.m (38 +/- 2 ft-lb) 

  3. Confirm that the toe-in is at the standard value.
scientia non olet · About LEMON Manuals