Removal And Installation: Notes

WARNING: This page is about a different variant/trim than selected.

CAUTION:

Take care not to contact the parts or tools to the caliper because the paint of caliper will be scratched. And if there is brake fluid on the caliper, wipe it off quickly.
For vehicles with ABS, do not strike the rotor for wheel speed sensor installed to the BJ outer race of drive shaft against other parts when removing or installing the drive shaft. Otherwise the rotor for wheel speed sensor will be damaged.
*:Indicates parts which should be temporarily tightened, and then fully tightened after installing the engine into the vehicle.

Pre-removal and Post-installation Operation

Under Cover Removal and Installation
Side Under Cover Removal and Installation
Transaxle Oil Draining and Supplying (Refer to TRANSAXLE OIL REPLACEMENT .)
Engine Coolant Draining and Supplying (Refer to ON-VEHICLE SERVICE .)
Crossmember Bar Removal and Installation (Refer to REMOVAL AND INSTALLATION .)
Front Exhaust Pipe Removal and Installation (Refer to REMOVAL AND INSTALLATION .)
Air Cleaner, Air Intake Hose Removal and Installation (Refer to AIR CLEANER .)
Strut Tower Bar Removal and Installation .)
Air Hose E. Air By-pass Hose and Turbocharger Bypass Valve, Air Pipe C, Air Hose D, Air Pipe B, Air Hose A Removal and Installation (Refer to CHARGE AIR COOLER .)
Radiator Removal and Installation (Refer to CHARGE AIR COOLER .)

Fig 1: Identifying Transfer Assembly (1 Of 2)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 2: Identifying Transfer Assembly (2 Of 2)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Required Special Tools: